Gardebruk Deuba ASX900 Manual Del Usuario página 32

32
WARNING: Do not use any attachments or accessories not recommended by the
manufacturer of this product. The use of attachments or accessories not recommended
can result in serious personal injury.
Adding bar and chain lubricant
Use Bar and Chain Lubricant. It is designed for chains and chain oilers, and is formulated
to perform over a wide temperature range with no dilution required.
NOTE: Pole saw comes from the factory with no bar and chain oil added. Level should
also be checked after every 20 minutes of use and refilled as needed.
Remove oil cap. Carefully pour the bar and chain oil into the tank. Wipe off excess oil.
Check and fill the oil tank when quick view oil indicator is below the second to last
indicator line. Repeat as needed.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage,
empty the oil tank after each use then run for one minute. When storing the unit for a
long period of time (three months or longer) be sure the chain is lightly lubricated; this
will prevent rust on the chain and bar sprocket.
Connecting to power supply
This product is designed with a cord retainer that prevents the extension cord from
being pulled loose while using. Form a loop with the end of the extension cord. Insert
loop portion of extension cord through opening in the bottom of the rear handle
and place over cord retainer. Slowly pull loop against cord retainer until the slack is
removed. Plug product into extension cord.
NOTE: Failure to remove all excess cord slack from extension cord retainer could result
in plug loosening from receptacle.
Starting and stopping
To start the motor: Connect the pole chain saw to power supply. Place your thumb on
the lock-off button and pull it completely towards you. Fully depress the switch trigger.
To stop the motor: Release the switch trigger.
Adjusting telescopic pole
Disconnect the pole saw from the power supply. Rotate the collar counterclockwise
to loosen. Push poles towards each other to shorten the pole or pull away from each
other to lengthen the pole.
NOTE: Extend the pole only to the length required to reach the limb being cut. Do not
extend the handle above waist height. When the desired length is achieved, rotate the
collar clockwise to secure.
NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do
not attempt to use the pole saw at a length which does not allow you to achieve proper
www.DeubaXXL.de