Maintenance And Service; Maintenance And Cleaning - Berner BACIS BL12V Manual Original

OBJ_BUCH-3430-001.book Page 18 Monday, November 20, 2017 10:37 AM
Property Classes Standard Screws/Bolts
according to DIN 267
3.6
M 12 22.6
M 14 36
M 16 55
Tips
Before screwing larger, longer screws into hard
materials, it is advisable to predrill a pilot hole with
the core diameter of the thread to approx.
screw length.
Note: Pay attention that no metal particles enter
the power tool.
Belt Clip (see figure D)
With the belt clip 16, the machine can be hung on-
to a belt. The user has both hands free and the ma-
chine is always at hand.
Colour clip (see figure E)
You can use the colour clip 17 to individually label
the power tool.
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Store the battery only within a temperature range
between –20 °C and 50 °C. As an example, do
not leave the battery in the car in summer.
Occasionally clean the venting slots of the battery
using a soft, clean and dry brush.
A significantly reduced working period after char-
ging indicates that the battery is used and must be
replaced.
Observe the notes for disposal.

Maintenance and Service

Maintenance and Cleaning

 Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as du-
ring transport and storage, remove the battery
from the power tool. There is danger of injury
when unintentionally actuating the On/Off
switch.
 For safe and proper working, always keep the
machine and ventilation slots clean.
In all correspondence and spare parts orders, ple-
ase always include the 6-digit order number given
on the nameplate of the machine.
18 | English
4.6 5.6 4.8 6.6
30 37.6 40 45
48 60 65 72
73 92 98 110
Transport
The contained lithium-ion batteries are subject to
2
/ of the
the Dangerous Goods Legislation requirements.
3
The user can transport the batteries by road wit-
hout further requirements.
When being transported by third parties (e.g.: air
transport or forwarding agency), special require-
ments on packaging and labelling must be obser-
ved. For preparation of the item being shipped,
consulting an expert for hazardous material is re-
quired.
Dispatch batteries only when the housing is unda-
maged. Tape or mask off open contacts and pack
up the battery in such a manner that it cannot move
around in the packaging.
Please also observe possibly more detailed natio-
nal regulations.
Disposal
The machine, rechargeable batteries, acces-
sories and packaging should be sorted for
environmental-friendly recycling.
Only for EC countries:
Guideline 2006/66/EC, defective or used battery
packs/batteries, must be collected separately and
disposed of in an environmentally correct manner.
Battery packs/batteries:
Li-ion:
Please observe the instructions in section Trans-
port, page 18.
Subject to change without notice.
High-strength Bolts
5.8 6.8 6.9 8.8
50 60 67 80
79 95 107 130
122 147 165 196
Do not dispose of power tools and batte-
ries/rechargeable batteries into household
waste!
According to the European Guideline
2012/19/EU, power tools that are no lon-
ger usable, and according to the European
1 609 92A 44J • 20.11.17
10.9 12.9
113 135
180 215
275 330