Speaker Volume & Volume Control Buttons; Resetting The Headset - Jabra BT300 Manual Del Usuario

Making a Call Using Voice Dialing (Voice dialing on your phone must be turned
On and voice tags stored)
1. Place the headset in the desired wearing style.
2. On the headset - Press the Multi Function Button (MFB) for more than 2 seconds.
3. A short tone will prompt you to say the name of the person you wish to call (as
entered in the phone's voicedial phonebook directory). Speak the voice 'tag' name.
4. The phone automatically dials your selection, and you see the details of the call on the
phone screen.
5. When connected you are free to communicate normally via the headset.
(Note : Please refer to the phone user guide for instructions on storing voice tags.
Some mobile phones need you to initiate voice dialing from the handset)
b) Ending a call from the headset
To end a call when wearing the headset - press the headset's MFB.
c) Receiving/ Answering a call
If there is an incoming call while you are wearing the headset a ring tone will sound in
your headset, just press the headset's MFB button to answer the call. If you are not
wearing the headset, then place the headset on your ear in the normal wearing
position and use the MFB to accept the call.
14
d) Transferring a Call
Transferring a call from the headset to your phone:
Must be initiated by the phone (refer to the user guide that accompanied your phone).
Speaker Volume & Volume Control Buttons
Volume up + and volume down –
button will regulate the volume to the
speaker in steps. One step per key
press increases / decreases the desired
volume until a satisfactory level is
reached. An audible tone is played for
each step +/- and when either the
minimum or maximum volume has
been achieved.

Resetting the Headset

In order to reset the headset to it's default settings – Hold down the power button and
the volume + button at the same time for 5 seconds. The reset will then install all the
default settings.
15