Axxess AX-ADFD100 Instrucciones De Instalación página 5

Applications
LD-AX-ADFD02
FORD
Edge
(4.2" screen only)
Escape
(4.3" screen only)
Explorer
(4.3" screen only, excluding STX, FX2, XLT base)
F150
(4.3" screen only)
F-250/350/450/550
(4.3" screen only)
Fiesta
Focus
(4.3" screen only)
AX-ADFD100
Connections to be made
LD-AX-ADFD02 vehicle applications
From the 16-pin harness to the aftermarket radio:
2011-2014
• Connect the (2) Red wires to the ignition wire.
2013-up
2011-up
• Connect the Orange/White wire to the illumination wire. If the aftermarket radio
2013-2014
does not have an illumination wire, tape off the Orange/White wire.
2013-up
2011-up • Connect the Blue/White wire to the amp turn on wire.
2012-2014
• Connect the Brown wire to the mute wire. If the aftermarket radio
does not have a Mute wire, tape up the Brown wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
Only make the following connections if the vehicle contains the SONY/THX
amplified system.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
Continued on next page
5