Keypad Functions - Facom 1370 Manual De Instrucciones

3 MODULE FUNCTIONS
The FACOM 1370
specially designed for digital display measuring instruments.
RÉF:
Printer with built-in microprocessor for processing the data.
MODE 1: statistics and printing :
- recording and processing up to 1000 readings,
- number of measurements,
- maximum and minimum values,
- scope of acceptance,
- arevage reading,
- typical deviation,
- typical deviation per population,
MODE 2 : tolerances :
- tolerances,
- values outside tolerances (+ and -),
- % of rejects,
MODE 3 : histogram : Histogram printout of data recorded in mode 2

4 KEYPAD FUNCTIONS

9
10
8
7
1 on/off switch
2 "MODE" switch
3 "START" button
4 "RESTART" button
5 "STATISTIQUE" button
HISTOGRAMME
6 "CANCEL" button
7 "DATA" button
8 "FEED" button
9 Accept /Reject
Accept : green LED
10 Accept /reject
Reject : red LED
statistical processing module with printer has been
1300, 1330, 1340, 1350, 1355 and 1360
3
"NORMAL" mode
Red LED lights up for ON
Selects "NORMAL" mode
Deletes all of the data and starts
measurement
Deletes the measured values and
restarts the measurement using
the sample 1.
Makes the statistical calculations
and prints the results .
Deletes the last value entered.
Enters data
Feeds the paper
LED lit
LED extinguished
2
6
"LIMIT" mode
Same as "NORMAL" mode
Selects "LIMIT" mode
Same as "NORMAL" mode
Deletes the measurement values
but retains the tolerances and
restarts the measurement using
the sample 1.
Makes the statistical calculations
and prints the results. Pressing
this button again prints out the
histogram of the results .
Same as "NORMAL" mode
Same as "NORMAL" mode
Same as "NORMAL" mode
LED lit : the measured value is
within the tolerances.
LED lit: the measured
value is out of tolerances.
1
4
5