Eldom rex MZ300 Manual De Instrucciones página 14

INSTRUCTION MANUAL
EN
PET HAIR CLIPPER MZ300
DESCRIPTION OF THE SET
1.
Cutting head
2.
Hair length control ring
3.
Switch-key
4.
Control lamp
5. Comb heads (3 mm, 6 mm, 9 mm, 12 mm)
6.
Feeder
7. Maintenance oil
8.
Cleaning brush
9.
Battery
10. Charging port
OPERATION
Before the first use, put the battery in, phot. 1. The MZ300 can be used as an appliance
powered by electricity or a battery. If the appliance is powered by electricity, it is ready to
be used right away.
ELECTRIC POWER SUPPLY
- Turn off the appliance, the switch-key (3) in position "0".
Plug in the feeder (6) and connect it to the hair clipper.
-
Power supply is signalled by the red control lamp (4).
-
To start operation, turn the switch-key (3) to position "1".
-
when finished, turn off the device by pushing the switch (3) down and disconnect the
-
power cable from the socket and then from the device port (10)
CHARGING AND OPERATION WITH THE BATTERY
Turn off the appliance, the switch-key (3) in position "0".
-
Plug in the feeder (6) and connect it to the hair clipper.
-
- Charging is signalled by the red control lamp (4).
Battery charging time: approx. 8 hours
NOTICE: The control lamp (4) does not go out after the battery has been charged.
- After the battery has been charged, disconnect the feeder, the appliance is ready for
operation with the battery. To start operation, turn the switch-key (3) to position "1".
Charging the battery for over 12 hours reduces its life span. If the appliance is not used for
a longer period of time, it is recommended to charge the battery at least once every half a
year. Failure to charge the battery for a period of over 6 months also
14
TECHNICAL DATA
supply voltage: 220-240V ~ 50Hz
power: 3 W
battery: 2 x 900mA, Ni-Cd
charging time: 8 hours