Cleaning And Maintenance - Eldom rex MZ300 Manual De Instrucciones

HAIR CLIPPING
Set the switch (3) in the "0" position,
-
- Make sure the appliance is clean, correctly assembled and oiled.
- Before clipping the hair, comb it to make it more natural.
Install the right comb head (5) by sliding it in the side slideways of the cutting head
-
(phot. 2). To remove the comb head, press the "PUSH" area on the comb head and move
it according to the indicated direction.The rotating ring (2) allows for precise control of
hair length: 0.8 mm - 2 mm. Additional comb heads (5) of 3 mm, 6 mm, 9 mm and 12
mm, and the 5-grade control ring offer 25 different hair lenghts.
- It is recommended to start clipping with the use of the comb head for longer hair.
To start the appliance, place the switch (3) in the "I" position
-
- The appliance must be running when it is put in contact with the coat.
- Trimming is best started from the neck, progressing towards the tail.
- Without using the comb heads, the hair can be clipped evenly to the length of 0.8-2 mm.
CAUTION. Be cautious when trimming hair in sensitive spots, such as face, stomach, etc.
Trim small areas, slowly passing the appliance along the natural direction of the coat.
CAUTION. Do no use the hair clipper for wet hair. The head (1) becomes hot when
in operation, which is natural. Switch off the appliance from time to time, using
the switch (3), and check whether the head (1) is not too hot. If this is the case, stop
trimming and wait for the head (1) to cool down.

CLEANING AND MAINTENANCE

Before cleaning, unplug the appliance and turn it off.
Do not use any cleansing agents which are strong or may damage the surface.
Wipe the casing with a moist or dry cloth.
After using the appliance, the chamber of cutting knives should always be cleaned. For this
purpose, open the cutting head (1) by pressing the clipper blades with your thumb in the
direction shown in phot. 3.
Protect the blades against falling down.
NOTICE. Before opening the cutting head, turn the hair length control ring (2) to
position "2 mm".
Clean the blades with the brush included in the set.
Cutting blades must be maintained on a regular basis.
Put one to two drops of oil between the blades and turn the appliance on for a few seconds.
Do not use hair oils, fat, oils mixed with refined kerosene or other solvents.
Do not immerse the appliance in water.
The knife is an utility tool and should be replaced regularly.
The knife is not covered by guarantee.
15