Tabla de contenido
Publicidad
EN
INSTRUCTIONS FOR PROGRAMMING
TS1 INFRA-RED REMOTE CONTROL
SELECTOR AT 433 Mhz
GENERAL INSTRUCTIONS:
The TS1 is a 433.92Mhz remote rolling code selector fed by a 3V lithium battery (CR2032).
It is recommended to protect the product against frigid temperatures or heat sources as they may compromise
the battery efficiency.
RADIO CONTROL PROGRAMMING:
To enter into the self-learning phase, follow one of the following methods:
1 - from the automation's electronic board: press the DOWN key until appear RADIO;
2 - from the DS2 digital program switch: access the menù OTHER-RADIO-ACQUIRE
Press key 2 on TS1 remote control. Upon receipt of a valid code the word RADIO turns off. The remote has
been programmed and is ready to use.
DELETING PROGRAMMED RADIO CONTROL
To delete the programmed radio controls, , follow one of the following methods:
1 - from the automation's electronic board: press and hold the 'A' key , the led start to blink. Press again the 'A'
key and hold for 5 seconds, the led stay off;
2 - from the DS2 digital program switch: access the menu OTHER-RADIO-DELETE.
BATTERY REPLACEMENT :
Unscrew the screws and open the remote control.
Remove the run down battery and replace it;
Pay attention to observe the correct polarity.
During the replacement operation, handle the battery
as shown in the diagram.
2
TS1
EN
TS1
Publicidad
Tabla de contenido
