Promate SolarTrail-2 Guia Del Usuario página 5

Operation Instructions:
2 r a i l - T a r o l S
1
2
1. Please use the card to measure hole position correctly and drill 3 holes.
2. Fix 3 expansion plugs into the holes.
3. Fix 3 screws into the expansion plugs with a spare space.
4. Insert the notch to the lower screw and fasten the whole lamp well.
5. Press the back button to adjust to the demanded working mode.
Mode A: Automatically turns on at dusk and remains 20% bright for up to 5 hours
before turning itself off
Mode B: Automatically turns on to full brightness (400lm) when motion is detected in
the working range, and then turns to 3% brightness in 20 seconds when no motion is
detected
Mode C: Automatically turns on to full brightness (400lm) when motion is detected in
the working range and then turns itself off in 30 seconds when no motion is detected
Notice
• This is a solar-powered lamp; please install it in a location where it can get enough
sunshine.
• Please note the lighting time depends on sunshine duration and weather.
• The lamp will light up automatically at dusk.
• Built-in intelligent IC overcharge, over-discharge, and over-voltage protection.
4
3
SolarTrail-2
English
Button
5
Notch
4
4