Reference; Firmware Upgrade - Samsung DVD-P390K Manual Del Usuario

reference

Firmware upgrade

Introduction
Samsung will often support the software upgrade to
improve the performance of this unit to the latest sta-
tus, through Samsung Internet Site (www.samsung.
com).
Because the specially new mpeg4 codec continues and
it is appearing. What improvements are made depends
on the upgrade software you are using as well as the
software that your DVD-player contained before the
upgrade.
How to make an upgrade disc
Write the downloaded file onto a blank CD-R or CD-
RW disc, using the following settings:
1. You have to download a new file through Download Center
of Samsung Internet Site (www.samsung.com).
2. Write the file to Disc using CD-RW of your computer.
Note
- File System CD-ROM ISO Level
- Character set ISO 9660
- Finalized, single session
- Write speed low
Upgrade procedure
1. Open the disc tray. Place the disc on the tray. Close the
tray. The Firmware upgrade screen appears.
Firmware upgrade
appears on the display
2. Press the √/® buttons to select Total, then press the
ENTER button.
- In the middle of the writing, the tray will open
automatically. After taking out the disc, please wait for
about 2 minutes.
- If the unit was succesfully updated, the unit will turn off
and on after closing the tray automatically. When the
unit turns on, this screen will display.
π/†
3. Press the buttons and then press ENTER to select
the desired language.
Note
- If the "Select Menu Language" doesn't appear,
please contact to "Samsung Service Center".
- Do not press any button and unplug the power
cord during upgrade.
- The upgrade procedure may change, refer to
the web site (www.samsung.com).
Firmware upgrade starts
English
Français
Deutsch
Español
Italiano
Português
English _31