Publicidad
Idiomas disponibles
Idiomas disponibles
5. Commissioning and use
Connect the power cord to a properly wired power socket. First proceed as
described in Section "3 Commissioning".
Ensure that the power plug has been inserted. Insert up to two toast slices
into the toast slot. Turn the "rotary switch provided for adjusting the degree of
toasting" to the desired setting and press the "slide switch" down until it snaps in
place. The heating elements warm up and the toasting process begins.
Level
1-2
3
4-6
Once the process is complete, the "slide switch" automatically jumps back to its
original position. This means that the toasting process has finished and the bread
slices can be taken out carefully.
If the degree of toasting is not satisfactory, adjust it using the "rotary switch pro-
vided for adjusting the degree of toasting" and repeat the toasting again. In this
case, ensure that the toast does not get burnt. If the desired degree of toasting
has already been attained, you may then end the process at any time by pressing
the "CANCEL" key.
To use the bread roll attachment, place it on the toast slots as shown in the
picture in section 4 on page 10 (product details).
6. Adjusting the Degree of toasting
The "rotary switch provided for adjusting the degree of toasting" allows you to
specify the duration after which the toaster should automatically shut down. The
longer the device is switched on, the darker will be the bread at the end of the
browning time.
Note: In order to get optimal browning results, we recommend that you use only
settings 1 to 3 for toast and sandwiches. The higher browning settings 4-6 should
be used only if, for example, you want to use the bead roll warming rack for
24
Browning
low browning
medium browning
high browning
English
Publicidad
