Descargar Imprimir esta página

Sonos RM016 Manual Del Usuario página 29

Publicidad

USA
This device complies with Part 15 of the FCC Rules using limits for a Class B digital device. These limits
are designed to provide reasonable protection against harmful interference in a residential installation.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference
and (2) this device must accept any interference received, including interference that may cause
undesired operation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
All Sonos devices have in-products antennas. Users cannot reorient or relocate the receiving
antenna without modifying the product
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Caution: Modifications not expressly approved by the manufacturer may void the user's authority to
operate the equipment under FCC rules.
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
MEXICO
La operación de este equipo está sujeta a las siguientes dos condiciones:
1) es posible que este equipo o dispositivo no cause interferencia perjudicial y.
2) este equipo debe aceptar cualquier interferencia, incluyendo la que pueda causar su propia
operación no deseada.
CANADA
This class B digital apparatus complies with ISED CAN ICES-3(B), NMB-3(B), RSS-GEN, and RSS-247.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
The installer of this radio equipment must ensure that the product is located such that it does not emit RF
field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from
Health Canada's Web site
antenna orientation. However, they could place the complete product in a way that causes the problem
mentioned above.
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
Beam_LegalBooklet_640-00377.pdf 29
Beam_LegalBooklet_640-00377.pdf 29
www.hc-sc.gc.ca/rpb
. As mentioned before, the installer cannot control the
27
9/25/2018 12:05:39 PM
9/25/2018 12:05:39 PM

Publicidad

loading