3M Uvicator S-24402 Manual Del Usuario página 2

Hard hats are shipped with suspension uninstalled to
prevent distortion during shipping. The suspension must
be installed according to these instructions and must
be correctly adjusted to a snug fit in order to provide
maximum protection.
1. Turn hard hat shell upside down on its crown.
2. Place the suspension in the hard hat with the brow
pad toward the front brim of the hard hat.
(See Figure 1)
Figure 1
3. Fold one suspension key out and up. (See Figure 2)
Suspension Key
Figure 2
4. Slide suspension key into slot and press key fully
into slot. (See Figures 3 and 4) Repeat for remaining
three suspension keys.
Figure 3
PAGE 2 OF 12
ASSEMBLY
Figure 4
NOTE: Suspension webbing may initially be
tight upon installation of the keys.
5. Push down at the center cross with fist to ensure all
clips are secured and webbing is ready to be worn.
(See Figure 5)
Figure 5
ADJUSTING SUSPENSION SIZE
Ratchet Suspension – Do not overtighten.
1. Turn ratchet knob counterclockwise until the
headband opens to the largest size. (See Figure 6)
2. Place hard hat on head and turn the ratchet knob
clockwise until headband is snug and secure.
(See Figure 6)
Figure 6
0921 IS-24402