3M Uvicator S-24402 Manual Del Usuario página 3

REMOVING SUSPENSION
1. Place forefinger under the bend of a suspension key
and the thumb on the top of the key. Work key back
and forth while pushing upward with some force.
2. Repeat for remaining suspension keys.
ADJUSTING SUSPENSION HEIGHT –
VERTICAL ADJUSTMENT
The suspension is shipped set at medium height; if
adjusting higher or lower, follow these steps.
NOTE: If adjusting the suspension height after
inserting the suspension, remove the two
suspension keys nearest the suspension size
adjustment mechanism first.
1. The two suspension height keys are located near the
suspension size adjustment mechanism.
2. Turn suspension height key and strap
counterclockwise (90°), allowing user to remove the
suspension key from the headband strap.
3. Place in high or low slot and turn clockwise
(90°) to lock it into the appropriate height
adjustment slot. (See Figure 7)
Figure 7
4. Repeat steps 2 and 3 for opposite side of
suspension.
IMPORTANT! Ensure that both sides are at the
same height level.
5. Re-insert the suspension into the hard hat.
PAGE 3 OF 12
ASSEMBLY CONTINUED
REVERSE DONNING ORIENTATION (OPTIONAL)
NOTE: Hard hats marked with a reverse donning
arrow can be worn frontward or backward.
If reverse donning is desired, place the
suspension in the hard hat with the brow pad
toward the back of the hard hat. (See Figure 8)
Figure 8
0921 IS-24402