Rimage AutoPrism III Guia De Instalacion

AutoPrism III AutoPrinter ™ Setup and
Installation Guide
Before you begin:
This document describes how to set up your Rimage AutoPrism III AutoPrinter.
The instructions in this document are intended for people who are familiar
with hardware setup, software installation, and Windows operating systems.
If you do not understand the procedures in this document, ask your computer
technician for help.
Documents referenced in this procedure are found on the Rimage AutoPrinter
User Guide disc included with your system and are also available online at
www.rimage.com/support. From the Support menu select: Printer Series >
AutoPrinter > User Manuals tab.
Important!
This guide provides the information needed to set up an AutoPrism III
•
AutoPrinter. If you are using the Prism III printer as a standalone printer,
refer to the printer's setup and installation guide for instructions. If your
Prism III printer is part of an autoloader, refer to the autoloader's setup
and installation guide for instructions.
• Read all setup instructions thoroughly before you begin.
• Save all packing boxes and packing materials.
Notes:
Your product may not look exactly like the product pictured.
•
The term "AutoPrinter" is used throughout this document to refer to the
•
Rimage AutoPrism III AutoPrinter. The term "printer" is used throughout
this document to refer to the Prism III printer.
Unless otherwise indicated, all Windows navigation statements are
•
Microsoft Windows 7 paths. Other operating systems' navigation paths
may differ slightly.
# Required tools: Scissors or side cutters.
110824_H
1
Prepare the AutoPrinter
a. Cut the plastic tie wraps (Qty. 2) from the lift arm.
n Caution! Do not cut the belt or the cable!
b. Remove the shipping foam inserted above the carousel.
Shipping
Foam
2
Setup your Prism Printer
a. Unpack the Prism III printer. Refer to the label on the Prism printer
box.
Note: The Prism print ribbon is preinstalled.
b. Place the printer on the AutoPrinter so that the plastic printer feet
slide into the slots on the printer plate.
Slots
Printer Plate
Copyright © 2012 Rimage Corporation
3
Connect the Cables
Important! Make sure the power switch on the AutoPrinter is in
the Off position. Do not power on the AutoPrinter until prompted
to do so during the CD Designer Software Suite installation.
a. Connect the
printer cable
from the
AutoPrinter to
the Prism III
Tie
printer.
Wraps
b. Connect the USB
cable from the
Prism printer to
the control center
(PC).
Note: Make sure the power switch on the Prism III printer is in the
On position. Power to the Prism III printer is controlled by the
AutoPrinter.
4
Install the CD Designer Software Suite and Prism III
Printer Driver (PC Only)
Before you can operate an AutoPrism III AutoPrinter, you must install
the Rimage software (PC users only) and Prism printer driver.
Important! CD Designer is not Macintosh
Note: Unless otherwise indicated, all Windows navigation statements
are Microsoft Windows 7 paths. Other operating systems' navigation
paths may differ slightly.
a. Insert the Rimage CD Designer Software Suite disc that shipped
with the AutoPrinter into the PC disc drive.
b. Open the file named setup.exe.
c. Follow the prompts to install the CD Designer software and Prism
III printer driver.
c. Connect the short
power cord from
the AutoPrinter to
the Prism printer.
d. Connect the
power cord from
the AutoPrinter
to a suitable
electrical outlet.
® compatible.
Page 1