Initial Operation - Bosch Ciso Manual Original

OBJ_BUCH-894-001.book Page 44 Tuesday, November 25, 2008 2:22 PM
44 | English
Operation

Initial Operation

Switching On (see figures A1 – A2)
Dis-engage the safety lock 7 by moving the button as
shown.
1.
2.
Switching Off (see figure A3)
Release the On/Off switch 9 and allow it to return to
position "1.". The blade 2 will then return to the fully
open position.
Engage the safety lock 7 by moving the button as
shown.
Note: If the On/Off switch 9 is released quickly then the
blade 2 will not return to the fully open position, but will
stay in its current position. Pulling the On/Off switch 9 to
position "2." will return the blade 2 to the fully open po-
sition.
F 016 L70 560 | (25.11.08)
Fully insert finger and pull the
On/Off switch 9 back from pos-
tion „1." to postion „2." (work-
ing position) and hold.
3.
To close the blade 2 pull the
On/Off switch 9 back to postion
"3.". To open the blade 2 return
On/Off switch 9 to position "2.".
Bosch Power Tools