Candy CHICS 5184 Serie Manual Del Usuario página 13

① Stop block
② Self-tapping screw
9. Change screw hole covers on middle cover
plate from left to right (as shown in figure
below).
Screw hole cover
10. Lay the refrigerator on soft foam packaging or
similar material. Remove both adjustable bottom
feet parts, and remove the front feet board and
the lower hinge part by unscrewing the special
flange self-tapping screws.
①
②
③
④
①
Lower hinge part (right)
②
Front feet fixed board
③
Adjustable bottom feet part
④
Self-tapping screws
11. Unscrew the bottom hinge axis and remove it
to the hole which is side by side and screw it.
Washer
Note: washer may stick to lower door
12. Replace the lower hinge part to the left side
and fixing it with the special flange self-tapping
Screw hole cover
screws. Replace the front feet fixed board to
another side and fixing it with the special flange
self-tapping screws. Install the adjustable bottom
feet parts.
Lower hinge part (left)
front feet fixed board
13. Transfer the lower door to the property
position, adjust the lower hinge part, make the
hinge axis into the lower hole of the lower door,
then tight the bolts.
14. Upturn the middle hinge part the direction
180 degree, transfer it and adjust its position,
make the middle hinge axis into the upper hole
of the lower door, tight the bolts.
15. Transfer the upper door to the appropriate
position. Secure the door's level, make the
middle hinge axis into the lower hole of the
upper door.
middle hinge part
selftapping screws
11