Power Installation And Pci Fan Speed Controller Installation - Gigabyte 3D Rocket Cooler PRO GH-PCU22-VG Guia De Instalacion

Power Installation and PCI Fan Speed Controller Installation

Figure 1
Disassemble the turn knob, bolt and fan speed controller from
the 3.5" bracket and reassemble these parts onto a PCI bracket
in sequence.
Figure 1
Figure 2
Place the PCI bracket with the fan speed controller in the
selected PCI slot. Use screws to secure the PCI bracket in
place.
Figure 2
Figure 3
Connect the power cable of the power supply to the end of the
4-pin connector cable provided. Then connect the 3-pin power
connector on the fan speed controller to the 3-pin connector on
Figure 3
the cooler.
Figure 4
Installation is complete.
Figure 4
- 15 - GH-PCU22-VG