Device Setup; Using The Device In A Local Network; Replacing The Computer Ethernet Cables - Asus WL-330g Guia De Instalacion

Device setup

Using the device in a local network

You can use the WL-330g to connect a WLAN-enabled computer to a local
network with or without a DHCP server.
To connect a WLAN-enabled computer to a local network:
1. Switch the WL-330g to AP mode. (Default SSID: AP_xxxxxx), then turn on
the device.
2. Connect one end of the supplied RJ-45 cable to the Ethernet port of the
device and the other end to the Ethernet port of the local network.
3. Use the WLAN adapter software in the WLAN-enabled computer to
perform a Site Survey. Make sure the computer's WLAN adapter is set to
Infrastructure mode.
4. Establish connection with the WL-330g.
5. Set the IP configuration of the computer to establish connection to the
local network. Verify your connection.
Use the Wireless Setting Utility to change the WL-330g SSID or encryption
settings.

Replacing the computer Ethernet cables

You can use the WL-330g to replace your WLAN-enabled computer cable
connection to an ADSL or cable modem.
To do this:
1. Switch the WL-330g to AP mode. (Default SSID: AP_xxxxxx), then turn on
the device.
2. Connect one end of the supplied RJ-45 cable to the Ethernet port of the
device and the other end to the Ethernet port of the ADSL or cable modem.
3. Use the WLAN adapter software in the WLAN-enabled computer to
perform a Site Survey. Make sure the computer's WLAN adapter is set to
Infrastructure mode.
4. Establish connection with the WL-330g.
5. Set the IP configuration of the computer to establish connection to the
local network. Verify your connection.
ASUS Pocket Wireless Access Point (WL-330g) 19