Turntable On/Off; Temperature Units; Delay Start - Monogram Advantium ZSA1202 Manual Del Propietário

OTHER ADVANTIUM FEATURES

TURNTABLE ON/OFF

Use this feature to keep the turntable from turning when
using a dish is too large to rotate in the cavity.
TURNTABLE ON/OFF is not a permanent setting.
Press the SETTINGS pad, turn the dial to select
TURNTABLE ON/OFF and press the dial to enter. Turn
the dial to select TURNTABLE ON or TURNTABLE OFF,
press the dial to enter.
AUTO NIGHT LIGHT
Use this feature to set the surface light to come on and go
off at a certain time.
1. Press the SETTINGS pad, turn the dial to select AUTO
NIGHT LIGHT and press the dial to enter.
2. Select SET ON TIME and press the dial to enter.
3. Turn the dial to set on time hour and minutes, press
the dial to enter. Turn the dial to set off time hour and
minutes, press the dial to enter.
NOTE: Setting the hours sets AM/PM.
To disable the Auto Night Light feature:
Press the SETTINGS pad, turn the dial to select AUTO
NIGHT LIGHT and press the dial to enter. Turn the dial to
select DEACTIVATE and press the dial to enter.

TEMPERATURE UNITS

To change temperature units, press the SETTINGS pad
and select TEMPERATURE UNITS. Turn the dial to select
F or C and press the dial to enter.

DELAY START

Use this feature to delay when the oven will start cooking
in CONV BAKE, COOK BY TIME, COOK BY TIME 1&2,
DEFROST BY TIME, or DEFROST BY WEIGHT.
1. Press the COOKING OPTIONS pad.
2. Turn the dial to select DELAY START and press the
dial to enter.
30
NOTE:
• The turntable will not turn off in Speedcook, Broil, Toast,
or Microwave Sensor modes.
• A cooking cycle must be started within 5 minutes of
turning the turnable off, or the turntable will reset to the
on setting.
• The turntable will also remain off for cooking cycles
started within 5 minutes of the end of any cooking cycle
for which the turntable was off.
To check the Auto Night Light on and off times:
Press the SETTINGS pad, turn the dial to select AUTO
NIGHT LIGHT and press the dial to enter. Turn the dial
to select REVIEW ON/OFF TIMES and press the dial to
enter. The display will show the on and off time for the
Auto Night light.
NOTE:
• Auto Night Light will turn on the surface light to the night
setting, when the clock time matches the Auto Night Light
on time, even if the surface light is on the bright setting.
• Auto Night Light will always turn the surface light off
when the clock time matches the Auto Night Light off time
if the surface light is turned on.
3. Turn the dial to set the start time hour and minutes,
press the dial to enter.
NOTE: Setting the hours sets AM/PM.
4. Set the cooking mode.
The oven will start the programmed cooking mode when
the clock time and the delay start time are the same.
49-7000145 Rev.0