Blanco LINUS-S-F HD Manual Del Usuario página 5

Technical Data
Fields of application
• Can be installed in front of a window
• Simply lift out and put aside
• Pressurised hot water tank
• Thermally-controlled instantaneous water heater
• Hydraulically controlled instantaneous water
heater
It is not possible to operate the tap with low-
pressure hot water tanks (open boiler).
Operating pressure
• Min.
• Max.
• A pressure reducer must be installed above
5 bar in order to comply with Noise Class I.
Temperature
• Max. (warm water inlet)
• Recommended (energy saving) 60° C
• Water connection: hot-left / cold-right
Note
Pressure differences of more than 3 bar between
cold and hot water connection must be avoided
since, otherwise, the mixing ratio of hot and cold
water can deviate considerably from the lever
position.
Before installation and commissioning
Before the fitting is installed, the intake pipes must
be thoroughly flushed so that no swarf, bits of
hemp or other contaminants can enter the fitting.
Foreign bodies can enter the fitting through pipes
which have not been flushed, or the water system
in general, and damage the ceramic disks and
O-rings. The installation of a dirt filter is recom-
mended in all cases.
Before commissioning the fitting, unscrew the jet
regulator and flush well.
Installation
A tap borehole ø 35 mm is required. Flush all
pipes well in order to remove the dirt residues.
Position the kitchen fitting in the opening and
ensure that there is a seal between the fitting and
the surface below. In the case of stainless steel
sinks, mount the stabilising triangle from under-
neath against the sink to increase the stability.
Fasten the fitting with the mounting set (seal,
washer, nut).
Fasten the flexi-hoses (with the seals) to the hot
and cold water pipe. Make sure that when the
nuts are tightened, the connection pipes are
firmly held to prevent them becoming twisted or
detached from the body of the fitting.
Important information
• Do not kink the flexi-hoses
• Do not strain the flexi-hoses
• Only screw the flexi-hoses manually into the
• When connecting the flexi-hoses to the angle
0,5 bar Maintanance
10 bar
Jet regulator
1. Loosen jet regulator (12)
2. Flush jet regulator sieve under flowing water
3. Reinsert jet regulator
70° C
Replacing the cartridge
1. Shut off cold and hot water supply at the angle
2. Loosen coloured cap (2) and the holding
3. Remove lever
4. Remove the cartridge lock nut (4)
5. Remove cartridge (6) and replace
6. Assemble in reverse order
Care
In order that your BLANCO kitchen fitting will pro-
vide you with years of pleasure, we recommend
it is cleaned by wiping regularly with a soft cloth
(BLANCO microfibre cloth is recommended). Use
clean water or a mild cleaning agent.
On no account should abrasive (neither liquid nor
powder) cleaning agents or those containing alco-
hol or acid-based or other "aggressive" agents be
used. Scouring sponges are equally unsuitable.
The use of proscribed cleaning agents can dama-
ge the finish. Such damage is not covered by the
guarantee.
Guarantee
If a claim is made on the guarantee, the claimant
must produce the invoice on which the date of
purchase or installation is stated.
We reserve the right to make technical changes.
body of the fitting.
valves, they must be held firmly to prevent the
hoses becoming twisted or detached from the
body of the fitting.
valve
screw (2) of the lever (1)
5