Sheetlock ® Easy Roomside Installation - REVENT RVSH50 Guia De Instalacion

SheetLock
Installation
Watch the video: reventfans.com
WARNING: Disconnect all AC Power Breakers or Fuses before attempting
to cut into your ceiling.
1.) Place the provided sheetrock cutout TEMPLATE on ceiling where you wish the
FAN to be (DAMPER and electrical positions shown on TEMPLATE). We suggest
using painter's masking tape to hold the template in place while cutting. If there is a
pre-existing fan opening, use aligning windows to find it's edges. Either cut through
the provided guide slots in the TEMPLATE, or mark your cut lines with a pencil and
remove the TEMPLATE. Use a sheetrock jab saw to cut your fan opening in the
ceiling. Note: Measure the opening from your old fan. ReVent
RVSH70 fit most openings without cutting.
sheetrock jab saw
2.) Fold in ceiling joist mounts so that they're flush with the FAN housing.
ceiling joist mount
3.) Raise then slide the DAMPER up half way until the notch in the side of the
DAMPER aligns with the upper set of guides. Remove the DAMPER from the FAN.
FAN
Easy Roomside
®
TEMPLATE
fold ceiling joist
mounts flush with FAN
10
RVSH50 or
®
FAN
DAMPER
Remove
DAMPER
from FAN
at notch