Eldom RAPIDBLADE MT500 Manual De Instrucciones página 14

- Lower the device onto your face and slide it, while ensuring that the flat part of the comb (4)
is in full contact with the skin (Fig. 8).
- Figure 9 shows how to remove the comb (4).
- When finished, press the button (2) to switch off the unit and clean it.
Tips
- Replace the blade when trimming performance and comfort are reduced, but at least
once a year.
- The best results can be obtained when the skin and hair are clean and dry.
CLEANING AND MAINTENANCE
- Before cleaning the appliance, changing the blade, or any maintenance activities, switch off
the device by pressing button (2). The unit must be disconnected from the power supply.
- Clean the trimmer after each use.
- Do not use strong or cleaning agents or cleaning products which can damage the surface.
- Remove the comb (Fig. 9).
- Brush away any accumulated hairs.
- Switch the trimmer on briefly and rinse the blade with lukewarm water (Fig. 10).
- Rinse the comb with lukewarm water.
- Carefully wipe off excess water and allow all parts to dry completely.
- Never dry the blade with a towel or a tissue, as this can cause damage.
- All parts of the unit must be dry before subsequent use.
Note: The blade edges are sharp, so use caution when handling this product.
If damage is found, the blade must be replaced immediately.
Replacing the blade
Note: The blade edges are sharp, so use caution when handling this product.
The blade can only be replaced with the original
- Press the button (2) to turn off the trimmer.
- Carefully push the blade-release switch upwards, while gripping the blade on both sides
(Fig. 11).
- Hold the new blade by both its sides, slide into the body of the device, and press it in
place (Fig.12).
14 EN
.