Inverter DS-9UIBG Manual Del Usuario página 15

Introduction for buttons on remote controller
● It's defaulted to display set temperature when turning on the unit.There is no
display in the remote controller.
● Only for the models whose indoor unit has dual-8 display.
● When selecting displaying of indoor or outdoor ambient temperature, indoor
temperature indicator displays corresponding temperature and automatically turn
to display set temperature after three or five seconds.
9
I FEEL button
Press this button to start I FEEL function and "
controller. After this function is set, the remote controller will send the detected
ambient temperature to the controller and the unit will automatically adjust the
indoor temperature according to the detected temperature. Press this button again
to close I FEEL function and "
● Please put the remote controller near user when this function is set. Do not put
the remote controller near the object of high temperature or low temperature in
order to avoid detecting inaccurate ambient temperature.
10
LIGHT button
Press this button to turn off display light on indoor unit. "
controller disappears. Press this button again to turn on display light. "
displayed.
11
CLOCK button
Press this button to set clock time. "
"▲" or " " button within 5s to set clock time. Each pressing of "▲" or "
clock time will increase or decrease 1 minute. If hold "▲" or "
time will change quickly. Release this button when reaching your required time.
Note:
● Clock time adopts 24-hour mode.
● The interval between two operation can't exceeds 5s. Otherwise, remote contro-
ller will quit setting status. Operation for TIMER ON/TIMER OFF is the same.
12
TIMER ON / TIMER OFF button
● TIMER ON button
"TIMER ON" button can set the time for timer on. After pressing this button, "
icon disappears and the word "ON" on remote controller blinks. Press "▲" or
" "button to adjust TIMER ON setting. After each pressing "▲" or "
" will disappear.
" icon on remote controller will blink. Press
12
" will be displayed on the remote
" icon on remote
" button, 2s later,
" icon is
" button,
"
" button,