Kohler SYMBIO K-1341 Instrucciones De Instalación página 2

2. Carefully lift the front of the bath about 1" (2.5cm),
and insert the top flange of the apron frame into the
grooves in the wood blocks located underneath the
rim.
3. Center and push the apron frame up until it contacts
the underside of the bath rim. One end of the apron
frame will also wrap around and cover the corner
post.
4. Use a carpenter's square to square the apron frame
with the floor at both ends.
5. Align the pre-drilled holes in the apron frame with
those on the corner post.
6. Secure the apron frame to the corner post with the
three bolts, washers, and hex nuts provided. Be sure
the apron frame is square to the floor. Also secure
the corner post to the floor, and tighten any
remaining loose nuts.
7. Drill 1/8" holes through the side nailing-in flange.
Secure the nailing-in flange to the stud wall with
screws or galvanized nails.
8. Drill 1/8" holes through the bottom nailing-in flange.
Secure the nailing-in flange to the floor with screws
or galvanized nails. Shim beneath the bottom
nailing-in flange, if necessary.
B
1007224-2-
Corner
Post
Top Flange
Predrilled
Holes
Nut
Bolt
Washer
Square
Bottom Nailing-In Flange
(Shim As Needed)
2
Bath
Groove In Blocks
Underneath Rim
Lift
Apron Frame
Bolts, Washers
And Hex Nuts
Apron
Frame
Stud
Side Nailing-In
Flange
Square
Apron Frame
Kohler Co., Kohler, WI U.S.A.