Repair Service; Technical Specification - Aigostar 300008IWY Manual De Instrucciones

GB

Repair Service

Suspicious Problem
When you think the product has a malfunction, please check and confirm the following
situations before taking it to service center.
Problem Possible Reason
Sealing ring not installed properly
Difficult to close the lid Lid handle is not at the lid open position
Lid handle gets stuck
Pressure exists inside the cooker
Difficult to open the lid
Float valve stuck
The sealing ring wore out
Food debris attached to the sealing ring
Leakage from lid
Food debris attached to float valve gasket
Float valve gasket wore out
No float valve installed
The lid is not closed properly
Heating plate doesn't
Heating base malfunction
heat in operation state.
Circuit malfunction
Anomaly self-checking
Display anomaly judgement, please take the appliance to local dealer or service center for
repair or installation.
Indicator state Abnormal display Possible Reason
Display Open circuit of bottom sensor
Display Short circuit of bottom sensor
Short circuit of upper
Display
housing sensor
Display Overtemperature protection
Display Open circuit of press switch

Technical specification

Model Rated voltage/Rated frequency
300008IWY 220-240V~ 50/60Hz
11
Solutions
Position the sealing ring well.
Turn lid handle to lid open position
Send the appliance to repair service for overhaul
Wait till safety valve completely drops down
Pat the lid
Remove steam vent, press the float valve lightly with sharp
object. If it doesn't work, send it service center.
Replace the sealing ring
Clean the sealing ring
Clean float valve gasket
Send appliance to repair network to replace float valve gasket
Install float valve
Close the lid again
Send the appliance to repair service for overhaul
Solutions
Please return the appliance to service center
for repair.
Please return the appliance to service center for
repair.
Please return the appliance to service center
for repair.
Please check whether there is water or food in
the pot; press "Cancel" button after adjustment,
the appliance can be normally used after beep
stops; otherwise, send it to repair network.
Please return the appliance to service center
for repair.
Capacity Pressure
Rated power
900W 5L 70kPa
Circuit Principle Diagram
220-240V~50/60Hz
Temperature fuse
L
Circuit breaker
N
E
Socket
Electric hot tray
This appliance is labeled in compliance with
European directive 2012/19/EU for Waste
Electrical and Electronic Equipment (WEEE).
By ensuring that this appliance is disposed of
correctly, you will help prevent any possible
damage to the environment and to human
health, which might otherwise be caused if it
were disposed of in the wrong way.
DISPOSAL: Do
The symbol on the product indicates that it
not dispose
may not be treated as normal household
this product as
waste. It should be taken to a collection point
unsorted
for the recycling of electrical and electronic
municipal
goods.
waste.
Collection of This appliance requires specialist waste
such waste disposal. For further information regarding the
separately for
treatment, recovery and recycling of this
special
product please contact your local office, your
treatment is
household waste disposal service, or the shop
necessary.
where you purchased it.
All contents of this manual have been carefully checked. In case of any printing errors
and omissions or any resulting misunderstanding, please consult us.
Note: This product is subject to any technical improvement which will be incorporated
into the new version of this manual in the future without the prior notice. Any change in
the appearance and colour of the product is subject to the real object.
WARRANTY: 2 YEARS
GB
L Connecting line
N
Lid open/close
check switch
Power
panel
θ
Temperature sensor of upper housing
Display panel
θ Temperature
sensor of base
Pressure
sense switch
12