Power On/Off; Ttl Mode - Rollei HS Freeze 4s Manual Del Usuario

Operation
Power on / off
• Switch on: Press and hold the power button for about 2 seconds
until the LCD screen will lights up and loads the menu system .
• Switch off: Press and hold the power button for about 2 seconds
until the LCD screen turns totally black .

TTL Mode

1 . Enter Menu 1 and press the second function button repeatedly until the display
shows TTL on the LCD .
2 . Press the third function button to change the sync mode . Choose between
normal mode or high speed mode .
3 . Enter Menu 2 to set the channel and the group of the flash .
4 . Choose the wireless remote control mode according to the trigger
that you are using .
5 . The exposure value can be adjusted from -3 .0 up to +3 .0 directly on the flash
by rotating the power output wheel . The value can be adjusted by 1 f-stop
increment by pushing the power output wheel once and then turning it around
(clockwise to increase the value and counter clockwise to decrease the value) .
The value can also be adjusted by 1/10 f-stop by just turning the power output
wheel without pressing .
Note: If you use a trigger the value of the flash will not be overwritten by the value
set on the trigger . For example if your flash shows an EV of +1 .0 and your trigger
shows a value of +2 .0, then the picture will have a real exposure value of +3 .0 .
If the flash shows an EV of +3 .0 then you are able to even get a higher exposure
value by setting the trigger to also +3 .0 and then the maximum exposure value of
+6 .0 will be reached . The same goes for the negative exposure values .
29