Rollei Rock Solid Beta 180 Instrucciones De Uso página 10

Short center column for lowest position
10
To change the center colum, loosen the screw below the platform by using the
3mm allen wrench (A). One turn is enough to loosen the platform. Then unscrew
the platform (B) as well as the hook at the bottom of the center column. Remove
the standard center column and insert the short one. Afterwards screw on the
platform again. Please note that the short center column has a safety lock at the
bottom. If you want to take out the short center column you need to bring the
safety lock into a position that the center column can be removed.
To use the tripod in the lowest position please use the short center column. It
provides 360 degrees horizontal and 180 degrees vertical adjustments.
1
Center column locking knob
2
Tilt locking knob
3
Pan locking knob
Auto Safety Lock
Insert the auto safety lock to the slot of tripod, rotate the short center column
anticlockwise to 120 degrees, push the short center column to the slot of tripod.
The auto safety lock will lock automatically and prevent the short center column
for accidently fall off. Rotate the auto safety lock anticlockwise to 120 degrees
then pull out the short center column.
1 Rotate the lock
2 Take out or insert
3 Auto Safety Lock
ENGLISH
B
360°
180°
1
A
1
Low
Position
2
3
2
3