Uline H-7555 Guia De Inicio Rapido página 2

Figure 2
Figure 3
Figure 4
1. Attach brackets to keyboard tray glide using small
screws and a Phillips screwdriver. (See Figure 5)
Figure 5
PAGE 2 OF 6
INSTRUCTIONS FOR UNIT ASSEMBLY
1. Start with the lowest shelf. Snap the interlocking pieces of a
Shelf
shelf support (wide end down) around the post at the lowest
Support
groove where shelf is to be located. Slide the support up or
down until it snaps onto the groove. Add a shelf support to the
same place on the remaining posts. (See Figure 2)
2. Slide post through underside of shelf until shelf slides firmly
over supports. (See Figure 3)
3. Stand unit upright. Gently tap shelf down to secure it. (See Figure 4)
NOTE: Keep casters in locked position to keep unit from rolling
during remainder of assembly.
4. Repeat steps 1 through 3 to attach the remaining shelves.
KEYBOARD INSTALLATION
2. From top of shelf, slide the bolt and large washer
down through wire shelf and into bracket hole. From
the bottom of the shelf, slide the small washer onto
the bolt and secure with wing nut. (See Figure 6)
3. Repeat step 2 for remaining brackets.
1-800-295-5510
uline.com
Figure 6
0221 IH-7555