Bang & Olufsen BeoSound Essence 2nd generation Manual De Instrucciones página 14

14
You can connect multiple sources to your BeoSound
Essence, either using the connection panel or wirelessly
through your network. However, only one source
can be active at a time.
A
~
Mains supply
Use the enclosed mains cord only.
B
Network setup button
To set up a wireless connection to a new network,
press the network setup button and wait for the
network status indicator to flash orange, see page 5.
C
Network status indicator
– Off: Product is switched off.
– White (flashing): Product is starting up.
– White (solid): Connected to your network.
The wireless signal strength is strong.
– Orange (solid): Connected to your network.
The wireless signal strength is poor.
Move BeoSound Essence closer to your router.
– Orange (flashing): In network setup mode,
see page 4.
– Red (solid): Connected to your network.
The wireless signal strength is very poor.
– Red (flashing): Searches for a wireless network.
D
ETHERNET
Ethernet socket for a wired connection.
No setup is required.
Connections
A
C
B
E
LINE IN (R/L)
Phono sockets for connection of external audio sources,
for example, an MP3 player or a computer.
F
SPEAKERS (PL 1/PL 2)
Speaker sockets for connection of Bang & Olufsen
speakers. To connect BeoSound Essence to an existing
Bang & Olufsen setup, contact your Bang & Olufsen
retailer.
G
IR-IN
IR socket for connection of an optional IR-receiver.
H
RESET
To return to factory settings, you can reset your
BeoSound Essence.
> Use a small pin, such as a straightened paper clip
to press and hold the RESET button for 10 seconds
until the product indicator flashes red shortly .
D E F G
> BeoSound Essence restarts automatically and is
reset to factory settings.
I
Product indicator
– Off: Product is in network standby.
– Green (flashing): Product is starting up.
– Green (solid): The indicator is solid green during
playback, when BeoSound Essence switches on,
and when using BeoSound Essence Remote. When
muted or paused, the indicator is also solid green.
– Red (flashing): A software update is in progress
during which the connected speakers cannot play.
Do not disconnect from the mains.
J
Power off/network standby
When in network standby, press the
switch BeoSound Essence off. Press again to switch
BeoSound Essence back to network standby.
H
I L
J K
button to