Controls & Functions; Mode Button; Mains Connection - Subzero SZPA-P12 Manual Del Usuario

Tabla de contenido

Publicidad

CONTROLS & FUNCTIONS
1. DIGITAL MEDIA PLAYER enables you to play
music through the speaker using a variety
of platforms. This device has the following
functions

MODE BUTTON

Change between different input modes
(USB, SD and Bluetooth)
PLAY/PAUSE BUTTON
(For USB and SD modes)
REPEAT BUTTON
For selecting play and repeat functions
SKIP
With short press / SCROLL with long press
DISPLAY SCREEN
SD CARD INPUT
USB DRIVE INPUT
BLUETOOTH WIRELESS RECEIVER
2. MIC GAIN KNOB
Increase and decrease the volume of the
microphone inputs (MIC IN 1 and MIC IN 2).
Note that this does not control the volume of the
wireless microphones.
3. LINE LEVEL KNOB
Increase and decrease the volume of the line
input.
4. ECHO KNOB
Increase or decrease the amount of echo to be
added to the inputs.
5. MP3 VOLUME KNOB
Increase or decrease the level of the digital
media player input.
6. VOLUME KNOB
Increase or decrease the overall volume of the
master output of the speaker.
7. MIC INPUTS
2 x TS ¼ jack inputs suitable for low impedence
microphone signals. Note, this input does not
support microphones that require phantom
power.
8. LINE INPUTS
Stereo RCA inputs suitable for high impedance
line level signals.
9. MIX OUTPUT
Stereo RCA output that provides a master
output of the speaker's mix at a line level signal.
10. GRAPHIC EQ – control the frequencies of the
master output at 100Hz, 330Hz, 1KHz, 3.5KHz
and 10KHz. Boost or limit the frequency by +/-
12dB.
11. WIRELESS MICROPHONE VOLUME KNOBS –
control the volume of the wireless microphones.
Power to the receiver can be switched on and
off using the on/off button.
12. BATTERY CHARGE INDICATOR – 4 level
indicator to show the battery life. The red light
indicator flashes when charge level is below
25%. At this point, you need to recharge the
battery as soon as possible to continue use.
13. & 14 ANTENNAS
Receive radio frequency signals from the
wireless microphones. Be sure these are
extended when in use with the wireless
microphones.
15. FUSE
This fuse is replaceable. Ensure to replace only
with a like for like fuse. Failure to do this could
damage the product. Before replacing, remove
the unit from any external power supply and
ensure the mains plug is not attached.

16. MAINS CONNECTION

Use only the power cable supplied with the
product. This power socket is fitted with a F1A
at 250V fuse. Ensure to replace only with a like
for like fuse. Failure to do this could damage
the product. Before replacing, remove the unit
from any external power supply and ensure the
mains plug is not attached.
17. POWER SWITCH
This turns the device on and off. Note, if the
power switch is off but still connected to a
mains connection, the battery will continue to
charge.
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Szpa-p15

Tabla de contenido