Publicidad
INTRODUCTION
Thank you for purchasing the SubZero Active DSP
Column PA. To help you get the most out of your
new product, please read this manual carefully.
CONTROLS & FUNCTIONS
1. Combo input: balance input, accepts "XLR
1/4"TRS" sockets
2. LINE /MIC selector
3. Input level control for CH1
4. Combo input: balance input, accepts "XLR
1/4"TRS" sockets
5. LINE/MIC selector
6. Input level control for CH2
7. RCA Ii nput: RCA Stereo Input
8 1/8" input: stereo unbalance signal
9. Input level control for CH3
10. Treble control: This potentiometer sets the
HIGH TONE level, if rotated clockwise it e
nhances the highs, if rotated counter clockwise
it reduces the highs (in the centre position the
response is flat).
11. Bass control This potentiometer sets the LOW
TONE level: if rotated clockwise it enhances the
lows, if rotated counter clockwise it reduces the
lows (in the centre position the response is flat).
12. LINEO UT: XLR mixer output for NEXT PA
system.
13. Power/Clip indicator Displays the input signal
status in color: Green: power ON, Red: Input
signal clipping.
14. Power switch: This switch can be used to switch
the diffuser on and off.
15. Fuse holder: Only r eplace the fuse when the
device is disconnected from mains. Only use
fuse of the same rating and power, the correct
fuse is specified on the rear panel.
16. Power input: Plug in the supplied power cable
here.
6
3
5
VOLUME
LINE
MIC
LINE
2
1
CH1
4
WARNING: THIS APPLIANCE MUST BE EARTHED
GEAR4MUSIC KETTLESTRING LANE YO30 4XF UNITED KINGDOM
14
4
POWER / CLIP
VOLUME
VOLUME
MIC
CH2
CH3
TO NEXT
CAUTION
RISK OF ELECTRIC SHOCK
DISCONNECT INPUT POWER
BEFORE OPENING. Ta=40°C
WWW.GEAR4MUSIC.COM
15
16
9
13
10
11
8
12
7
Publicidad
