Installation
CAUTION
• If you don't intend to use the ice maker, or if you are going for a business trip or
vacation, turn off the ice maker.
• Do not turn the ice maker on without the ice bucket in place. The ice cubes produced by
the ice maker will drop into and scatter through out the freezer.
• Noises may occur when the ice maker is making ice or being supplied with water, or
when ice cubes drop into the ice bucket. However, this is not a system failure. When the
ice bucket is full, none of these noises will occur.
• The first time you use the ice maker, or after you have replaced the water filter, the ice
made by the ice maker may have a carbon residue. If this happens, discard the first full
load of ice. Note that the carbon residue is harmless to humans.
26
English
Untitled-5 26
5. Tighten the provided screws (x2) to
attach the ice maker firmly to the
refrigerator.
- Make sure the screw holes are
aligned with each other before
tightening the screws.
6. Put the ice bucket on the shelf as shown.
By design, the ice bucket is supposed to
A
sit behind the ice maker. Otherwise, the
ice cubes from the ice maker will not
collect in the bucket as intended.
7. When installation is complete, turn the
refrigerator on, and then press Test
Switch (A) on the ice maker to check
if the ice maker operates and supplies
water for the ice tray normally.
2017-07-20
6:30:57