Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not place the heater near new walls, curtains or furniture while in operation. Always face
the heater towards the centre of the room when in use. Minimum clearance to combustibles
to the rear and sides of the heater behind the plane of the front panel 500 mm. Minimum
clearance to combustibles to the front panel 1.000 mm.
•
The heater must not be moved while operating.
•
Do not place objects on or against the heater.
•
The guard on this appliance is to prevent risk of fire or injury from burns and no part of it
should be permanently removed. It does not give full protection for young children or the
infirm.
•
This appliance should be leakage tested before initial use and whenever the cylinder has
been reconnected after filling.
•
Always close the gas cylinder valve whenever the heater is not in use.
•
For the connection of this device you need an approved gas hose (BS3212 type 2 or
BSEN1763 Class B) with a recommended length of 40 cm. It should be replaced if it appears
to be damaged or cracked. You need to check on this frequently. We recommend to replace
the gas hose every 3 years.
•
The gas hose should be connected in such a way that it can't be twisted.
•
You are obliged to replace the gas hose if national circumstances require.
•
This appliance is designed to operate with 5 kg till 15 kg butane or propane gas bottles, with
an adequate pressure reducing valve. See below schedule for gas and operating pressure:
Category
Gas and pressure
I3+ (28-30/37)
Butane 28 mbar /
Propane 37 mbar
I3 B/P (30)
Butane / Propane
30 mbar
I3 B/P (37)
Butane / Propane
37 mbar
I3 B/P (50)
Butane / Propane
50 mbar
Countries
Injector
GB, IE, BE, CH, ES,
Main burner: 0,55 mm
FR, GR, IT & PT
DK, FI, GR, LU, NL,
Main burner: 0,55 mm
NO & SE
PL
Main burner: 0,51 mm
AT, CH & DE
Main burner: 0,48 mm
EN-2
Heat input
3,7 kW (269 gr/h)
3,7 kW (269 gr/h)
3,7 kW (269 gr/h)
3,7 kW (269 gr/h)
Publicidad
