Brixton KA-5319 Manual De Instrucciones página 5

Operations
The heater can be regulated to three different heat input stages: LOW, MEDIUM and HIGH. The
ignition is operated by piezo electric push button.
•
Open the valve on the gas cylinder 1 ½ turns.
•
Press down and turn the control knob to LOW position and hold for 10 seconds.
•
While still pressing down the control knob, press several times on the ignition button until
the pilot flame ignited at the bottom of the burner. Continue to hold the control knob down
for another 10-15 seconds. When releasing the button and the pilot flame goes out, repeat
the operation.
IGNITION
•
When first igniting a new heater, it may be necessary to hold the control knob down for a
longer time in order to allow gas to flow to the pilot burner.
•
When the heater is burning at the LOW stage, please wait for around 4 minutes. The heating
element will start glowing and will become red. After that you can turn the control knob to
the MEDIUM position, again wait around 4 minutes in this position. Finally you can turn the
control knob to the HIGH position.
•
NEVER PUT THE APPLIANCE DIRECTLY ON THE HIGH-POSITION. AS A RESULT OF THIS THE
HEATER MIGHT NOT BE ABLE TO DIGEST THE GAS IN A PROPER WAY AND THERE MIGHT BE
EXCESSIVE FLAMING COMBUSTION.
In order to shut off the heater, you need to turn back the control knob to the start position and close
the cylinder valve fully (in clockwise); the heater can only be shut off by closing the gas cylinder valve
fully. It cannot be turned off by the control knob.
The heater will shut down if the ventilation in the room is not sufficient. If the heater should turn off,
ventilate the room well, and wait 5-10 minutes before re-lighting the heater.
LOW
MEDIUM
EN-4
START POSITION
HIGH