Publicidad
Idiomas disponibles
Idiomas disponibles
the ends of the railing, cut and insert into elements F23 locking them with article B02.
17. A ssemble articles F23 to the treads, in an intermediate position, using elements C14, B83, C49,
C13, B02 (fig.1) (fig. 3). Cut the balusters C03 to measure and secure in elements F23, locking
them with articles B02. Secure the balusters to the handrail A13 using articles C64. Check the
verticality of each baluster.
Final Assembly
18. C heck the distance between the treads and the wall (5cm approx.), the verticality of the entire
staircase and, if necessary correct by moving support N16 (fig. 1).
19. D ismantle the first tread (L19 or L20) and drill the floor using a Ø 14 mm point in the same place
as the openings found on support N16 (fig. 1).
20. Inserts elements C39 and secure in a permanent manner (fig. 1).
21. M ount the first tread back into position (L19 or L20) and secure to the floor, next to the first
baluster (C03), with element F01, drill using an Ø 8 mm point. Use elements B11, B12 and B02.
Insert the baluster (C03) and tighten element B02 (fig. 1).
22. C ut off the excess handrail next to the first and last baluster and complete assembly by inserting
element A12 using article C64 and glue X01 (fig. 1).
23.Insert articles B82 into balusters C67 to complete staircase assembly (fig. 1).
After you have finished assembling the staircase,
please visit our website and send us your suggestions: www.pixima.it
7 - MINI
Publicidad
