Cleaning & Maintenance; Cleaning The Filter; Spare Parts - Renfert Pillo Instrucciones Para El Servicio

6. Cleaning / Maintenance
Always disconnect the unit from the
compressed air supply before begin-
ning any maintenance tasks.
The Renfert deflasking chisel's motor is main-
tenance-free. Never use oil or grease on the
Renfert deflasking chisel. Occasionally clean
the exterior of the Renfert deflasking chisel with
a soft, dry, lint-free cloth.
Never use cleansers containing
solvents!

6.1 Cleaning the Filter

Regularly (at least every month) examine the
filter in the connector fitting (Figure 7) and clean
it as required.
Use only Renfert filters!
Filter replacement (Figure 7):
• Roll away the O-ring seal
• Unscrew filter housing (hold up at the filter
housing with the screwdriver attached).
• Using an Allan key (SW 5 mm) unscrew the
sleeve.
• Remove the sieve together with the filter unit.
• Install a new piece of non-woven material
and sieve making sure to adhere to the cor-
rect sequence (Figure 7).
• Screw the sleeve back in and hand-tighten.
• Screw filter housing together
• Replace the O-ring seal
The filter housing (Figure 7) must
not be removed from the connecting
tube. These will help maintain the
filter and will protect your Renfert
deflasking chisel against dirt and
other contaminants.
EN
6.2 Chisel Grinding
Dull chisels can be sharpened by grinding them.
Only tools and equipment intended specifically
for sharpening may be employed.
We can assume no liability for
damages resulting from improperly
ground chisels.

7. Spare Parts

You can find components subject to wear and
the spare parts on the spare part list in the
internet at www.renfert.com/p918.
The components excluded from the warranty
(such as consumables or parts subject to wear
and tear) are marked on the spare part list.
Serial number and date of manufacturing are
shown on the type plate of the unit.
8. Warranty
Provided the unit is properly used and with the
exception of components subject to normal
wear, Renfert warrants the all components of
the Renfert deflasking chisel for a period of 3
years.
Parts which are subject to natural wear and tear
(wear parts) and consumables are excluded
from the guarantee. These parts are marked in
the spare part list.
Components subject to natural wear are exclud-
ed from this warranty. The warranty is voided
in case of improper use; failure to observe the
operating, cleaning, maintenance, and connec-
tion instructions; in case of independent repairs
or repairs by unauthorized personnel; if spare
parts from other manufacturers are employed,
or in case of unusual influences or influences
not in compliance with the utilization instruc-
tions.
Warranty service shall not extend the original
warranty.
- 4 -