Connectivity Setup - JENN-AIR JFFCC72EFP Manual De Uso

IMPORTANT: Proper installation of your refrigerator prior to use is your responsibility. Be sure to read and follow the User Instructions
that came with your refrigerator.
Automatic Set-Up Instructions—Wi-Fi Protected Setup (WPS)
You will need:
A home wireless router capable of WPS. The router should
■
be ON and have a live Internet connection.
The Smart Appliance Identification Number (SAID) from your
■
refrigerator. This is located on a sticker on the front side of the
right-hand hinge cover of the refrigerator.
NOTE: If your home wireless router is not equipped with a WPS
button, please check the user manual of your router to confirm
if it is WPS capable. If not, alternate set-up instructions are at
www.jennair.com/connect.
1.
Setup router
Press the WPS button on the router. An indicator light will
begin blinking.
HELPFUL TIP: The WPS function on your router is active
for 2 minutes. Complete the next step within that timeframe
or you will need to reinitiate WPS.
8

CONNECTIVITY SETUP

(on some models)
2.
Setup refrigerator
(time-sensitive step)
Press and hold Connect button for 3 seconds on Home screen.
The Wi-Fi status indicator ( ) on the refrigerator control panel
will blink slowly while your refrigerator and router attempt to
connect.
If the connection is successful, the Wi-Fi status indicator will
come on and remain lit.
If Your Refrigerator Doesn't Connect:
If your refrigerator and router fail to connect after 2 minutes,
the Wi-Fi status indicator will blink rapidly for 5 seconds
and then turn off. Refer to the "Troubleshooting—Connected
Models" section of this Use & Care Guide, check any
connection instructions for your specific router, and refer to
alternate instructions at www.jennair.com/connect or call
1-877-559-2603.
NOTE: If this is your first Smart Appliance, you will need to
download the Jenn-Air app and create an online user account.
If you already have the app and a user account, please skip
ahead to Step 4 "Register your refrigerator in your user
account."
To disconnect Wi-Fi, press and hold Connect button between
7 and 15 seconds, the <Wi-Fi> and <house> icons will turn off,
indicating that you have disabled the Wi-Fi radio.
To reconnect Wi-Fi, press and hold Connect button for
3 seconds on the Home screen.