Whirlpool WRT108FZDW Manual De Instrucciones Para El Usuario página 7

NOTE: Make sure the washers are in place on both the top
and bottom pins of the center hinge.
A
⁵⁄₁₆
A. " Hex-head hinge screws
B. Washers
Reverse Freezer Door
1. Remove the three cabinet hole plugs from the top of the
cabinet and place them in the hinge holes on the opposite
side.
A
A. Cabinet hole plugs
2. Remove the door handles. See the model specific graphics
later in these instructions.
Door Handles Installed with Flat-head Screws and
Setscrews
Remove the two flat-head handle screws from the bottom
of the freezer door handle.
Using the ¹⁄₈" hex key, loosen the setscrew attaching the
top of the handle.
Pull the handle away from the door to release it from the
shoulder screw. Keep all parts together.
Door Handles Installed with Flat-head Screws Only
Remove the screw cover and the three flat-head handle
screws. Keep all parts together.
3. Using the plastic tool (provided), remove the brand badge
from the freezer door by prying up the right-hand side and
slowly peeling the badge away from the door, revealing the
hole to mount the door handle.
NOTES:
To avoid scratching the finish, do not use a sharp or
metallic object to pry the brand badge from the door.
Rub a small amount of liquid dish soap over any adhesive
residue with your fingers. Rinse the door with warm water
and dry with a soft cloth.
4. Depending on your model, remove the shoulder screw and its
washer from the left-hand side of the door and fasten it into
the hole that was behind the brand badge.
5. Remove the door stop from the bottom of the freezer door.
A. Door stop screw
B. Door stop
B
A B
6. Move the door stop to the opposite side making sure that the
hole in the door stop plate is aligned perfectly with the hole for
the center hinge pin.
7. Using the screw removed earlier, fasten the door stop to the
bottom of the freezer door.
A
8. Depending on your model, place the handle on the shoulder
screw and push the handle toward the door until the mounting
base is flush against the door.
9. Fasten the bottom of the handle to the bottom of the freezer
door.
10. Tighten all screws. Set aside the freezer door until the hinges
and refrigerator door are in place.
Reverse Refrigerator Door
1. Remove the door stop from the bottom of the refrigerator
door.
2. Replace the door stop on the opposite side of the refrigerator
door, making sure that the hole in the door stop plate is
aligned perfectly with the hole for the bottom hinge pin.
3. Fasten the door stop to the door.
4. Remove the door handles. See the model specific graphics
later in these instructions.
A. Door stop screw
A
A. Setscrew
A B
A. Door stop screw
B. Door stop
A
7