Mr Coffee ES Serie Manual De Usuario página 12

Important: Resetting Delay Brew at the Pre-Set Time
Due to a safety feature included in this unit, the programmable timer will not
automatically brew the next day after its last use. If the Delay Indicator Light in
the lower left hand corner of the clock display is not illuminated, then you will
need to reset the DELAY BREW feature by pressing the DELAY BREW button.
The programmable timer will not automatically brew the next day if left in the
AUTO position after its last use. This is a safety feature. If the OFF indicator light in
the lower right hand corner of the clock display is illuminated, reset AUTO BREW
by turning the control switch to OFF, then to AUTO. (Models ESX20, ESX23,
ESX20D, ESX23D Only)
Note: You do not have to set your clock before the Coffeemaker will operate.
Plug in the power cord, press SELECT once to turn the Coffeemaker on. The ON
light will illuminate and the clock will stop flashing, but it will not keep time.
1. Plug the power cord into your electrical outlet. The clock display will flash
until you set the time.
2. Alternately press and hold the HOUR and MINUTE buttons until you reach
the current time.
3. The PM indicator light in the display will illuminate to indicate PM time.
1. You must first set the clock to the correct time before setting the desired time
for Delay Brew.
2. Press the SET/DELAY button, then alternately press the HOUR and MINUTE
buttons to set the time you want the Coffeemaker to start brewing.
The Delay Indicator Light will flash during this time.
3. Press the SET/DELAY button again to turn off the flashing light. If the
Delay Indicator Light is not flashing, pressing the HOUR or MINUTE buttons
will change the clock time.
Brewing Automatically at the Preset Time
1. Follow Steps 1 – 5 in the "Brewing" Section.
2. Press the SELECT button. The Delay Indicator Light should illuminate.
3. Brewing will begin at the preset time. The coffee will remain hot in
the decanter for 2 hours. To keep your coffee hot for an additional 2 hours,
press the SELECT button. The ON indicator light should illuminate.
12
Setting Clock and Timer
(Programmable Models Only)
Setting the Clock
Presetting the Brewing Time