Wall Installation - ARDES AR4W05 Folleto De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
The power cable should be extended to its full lenght to avoid over heating.
If the power cable gets damaged, it has to be replaced only at a service centre
approved by the manufacturer.
For safety reasons, the appliance should never be opened.
The appliance has been designed and manufactured to operate in the home.
Any other use is considered inappropriate and dangerous.
Some parts of this product may become hot and cause burns. Particular attention
must be held if there are children or vulnerable persons.
Children between 3 and 8 years old should only turn on/off the product as long as
it was placed or installed in its normal operating position, if they are supervised or
if they got instructions regarding the safe use of the product, and they understand
the hazard.
Children between 3 and 8 years old should not plug it in, adjust or clean the
appliance or make the standard maintenance.
Do not insert objects through the safety grill or the air inlets.
Do not place the appliance directly under an electrical socket.
Do not use the heater close to sinks, bathtubs, showers and swimming-pools.
Do not use the heater in presence of flammable substances (petrol,paints, etc.).
Do not place the cord near sources of heat.
WARNING: DO NOT COVER THIS PRODUCT NEAR CURTAINS OROTHER
COMBUSTIBLE MATERIAL.
WARNING: DO NOT COVER THE APPLIANCE OR OBSTRUCT THE AIR
INLETS TO AVOID OVERHEATING.
DO NOT COVER
This product has been manufactured in conformity to current 2014/35/EU and
2014/30/EU
Technical data indicated on the appliance.
ASSEMBLY INSTRUCTIONS
Assembly kit composed of: 2 3,5 x 48 mm screws - 2 wall plugs.

WALL INSTALLATION

Fix the two plugs to the wall with the respective screws, taking into consideration
that the distance between them must correspond to that between the two hanging
holes on the back of the appliance. Leave the heads of the screws protruding out
from the wall enough so that the appliance can be hung on the screws. Once the
appliance has been hung on the screws, push it to the right so that the screws go
into the guide above the hole, thus improving the stability of the appliance.
The appliance must be installed at least 1.80m above ground and 15 cm from
the ceiling.
Operation.
The appliance can emit both cold and hot air, depending on how it is set.
Before connecting or disconnecting the appliance, make sure that all the switches
are in the off position.
6
INSTRUcTIONS fOR USE

Publicidad

Tabla de contenido
loading

Tabla de contenido