Allsteel AWARE Guia De Instalacion página 6

AWARE RECYCLE CREDENZA
Failure to install product as instructed, use of hardware other than that which is provided, or failure to comply
with instructions can result in product failure, personal injury, or property damage.
LABELING THE UNIT
Step 1: Clean the area thoroughly with rubbing alcohol or soap and water. Do not use Windex or
similar products because it will leave a residue behind that will prevent the sticker from adhering
well.
Step 2: Prepare the label for application by firmly rubbing a squeegee or credit card across the
clear transfer tape. This removes any air bubbles that may have formed and makes the sticker
cling to the transfer tape.
Step 3: Peel the white paper backing off the label. If the label clings to the backing, slowly replace
the paper backing and repeat Step 2.
Step 4: Locate the label edge approximately 1" to the left of the face plate cut-out and line up the
bottom of the label with the bottom of the face plate cut-out as shown.
Step 5: Slowly lower the label onto the surface and rub it in place firmly with a squeegee or credit
card. For best results, wait 24 hours before moving to the next step.
Step 6:Slowly peel the clear transfer tape off at an angle. Be careful not to pull the label off the
surface. If label pulls away from the surface repeat Step 4.
OF FACE PLATE CUT-OUT.
Pages 6 of 6
W A R N I N G
APPROXIMATELY 1.000
FROM EDGE OF FACE
PLATE CUT-OUT AND
FLUSH WITH BOTTOM
LABEL
Installation Packet
FACE PLATE
SEE DETAIL A
343-3773