Publicidad
Zigbee Network creation
Procedure to insert all the devices into the same Zigbee network, devices belonging to the same network can send and receive commands one of the other one
N
L
A
3s
Press, and hold for 3 seconds, the NETW button
of a device connected to the mains: the orange
indicator lights up steady as the network is
being created and then flashes quickly.
Adding a device to an existing network
N
L
A
A
B
/
C
Briefly press the NETW button of any device:
the orange indicator light flashes quickly.
Removing a device from the network
A
B
C
3 mm max.
Then briefly press the NETW button of a
device to be added to the network: its orange
indicator lights up steady and then flashes
slowly.
B1
A1
+
Repeat the operation for all devices (wired or battery-
powered) to be added to the network.
Note: if the indicator lights up steady and then turns off,
this means that the device is out of range.
Briefly press the NETW button of the device
to be added: its orange indicator lights up
steady and then flashes slowly.
C
Briefly press the NETW button of the device
to remove: the indicator light flashes
quickly.
To cancel the network, carry out the above step for all the devices.
N
L
B
A
When the indicator lights of all the devices are flashing, briefly press the NETW
button of the first device. The indicator lights of all the devices added to the
network will then turn off, except on the first device, where the indicator flashes
three times every three seconds.
A2
Bn
+
. . . +
N
L
C
A
Press the NETW button which opened the network: all the indicator lights turn
off.
Press, and hold for 10 seconds, the NETW button
until the orange indicator light turns off and then
flashes at high speed.
6
C
/
C
B
Publicidad
