Página 1
Installation manual Control box for outdoor units with integrated hydraulic components Installation manual English Control box for outdoor units with integrated hydraulic components EKCB07CAV3...
3.1.1 Installation site requirements of the control box..Daikin website (publicly accessible). Preparing electrical wiring ............▪ The full set of latest technical data is available on the Daikin 3.2.1 Overview of electrical connections for external and extranet (authentication required).
User interface User interface 100 mA Optional equipment Preferential kWh rate power supply (voltage- free contact) 2× Backup heater kit thermistor Installation manual EKCB07CAV3 Control box for outdoor units with integrated hydraulic components 4P404075-1C – 2017.03...
1 Insert the wiring from the bottom of the control box. 2 Make sure the low voltage wiring is located on the right. Route it through the intake hole and fasten it with cable ties. EKCB07CAV3 Installation manual Control box for outdoor units with integrated hydraulic components...
To connect the user interface ▪ If you use 1 user interface, you can connect it onto control box EKCB07CAV3 (for control close to the control box), or in the room Insert a screwdriver into the slots underneath the user (where used as room thermostat).
For instructions on how to configure and commission the system, and hand it over to the user, refer to the installation manual of the outdoor unit. EKCB07CAV3 Installation manual Control box for outdoor units with integrated hydraulic components 4P404075-1C – 2017.03...