König SAS-TRANS64 Manual Del Usuario página 2

English
Camera
Receiver
Switch to external display
Delete recording/Mute alarm
Left/Right to switch camera
Installation
1.
2.
3.
4.
5.
6.
SAS-TRANS64 Manual _Edit_0617.indd 2
Antenna
Infrared LEDs
Lens
PIR infrared sensor
Microphone
Bracket
Antenna
7"TFT-LCD
Menu / Back
Change display layout
Up/Down for volume
OK Button
Link Indicator
Insert a formatted SD card or connect an external hard disk to the display.
Note: external USB Hard Disk is not supported while on battery mode.
Attach the antenna to the camera.
Connect the camera using the power supply.
Connect the receiver using the power supply to fully charge the battery.
Switch on the receiver pressing the power button for 2 seconds.
Press the menu button to access settings menu shown on the right:
Antenna Socket
Pair Button
Power Indicator
Link Indicator
Power Input
Power Indicator
Power on/off
Loop Display Mode
Record/stop Video
Playback Video
Reset Button
USB Port
SD Card Slot
Bracket
AV Output Port
Power Port
9-8-2017 13:35:34