Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
When you pull the switch trigger, the tool performs the next
sequential operations as follows, and the tool stops automatically.
1.
Feed the wire.
2.
Cut the wire.
3.
The hook holds and twists the wire.
4.
The hook returns to the original position.
Tying strength setting
CAUTION:
Be sure to lock the trigger before
starting the adjustment. When you turn the power
on, never bring your limbs or face close to the
binding or rotating parts of the tool tip. Otherwise,
you may be injured.
You can set the tying strength by adjusting the tying strength
adjusting button. Tying strength is shown on the display panel.
1
► 1 . Tying strength adjusting button 2. Display panel
If the wire is broken off, tying strength will be lost. After
tying, check the twisted portion for breakage.
If the wire is broken off, adjust the tying strength using the
tying strength adjusting button, and tie the rebars again.
Remaining battery notification
When the battery voltage drops below the required level,
the tool will stop operating, an error tone will sound, and
the number "4" will appear on the display panel. The error
tone will continue to sound until the power is turned off.
NOTE: If the ambient temperature is extremely low,
the error tone may sound even when the battery
contains sufficient power.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Loading the tie wire (wire reel)
CAUTION:
tie wires and accessories, be sure to turn the
power off, lock the trigger, and remove the battery
cartridge. Failure to do so may cause an accident.
NOTICE:
ine tie wires (annealed wires) may cause the tool
to malfunction.
1.
Push the release lever, and lock it with the lock lever.
2
► 1 . Release lever 2. Lock lever
When you push the release lever, a gap is created
between the left and right feed gears.
► 1 . Release lever 2. Lock lever 3. Feed gears
8 ENGLISH
Always be sure that the tool is
Before mounting or dismounting
Using wires other than Makita's genu-
1
2
2
1
3
Publicidad
Tabla de contenido
