Before Use - Mellerware PAMPER PACK Manual De Instrucciones

3. Instructions for use

3.1. Before use:

3.1.1. Remove the appliance's protective film (if
applicable).
3.1.2. Before using the product for the first time,
clean the parts that will come into contact with
water in the manner described in the cleaning
section.
3.2. Use and care:
3.2.1. It is important that the water deposit is
filled with water, keeping in mind the MIN and
MAX levels, indicated by Fig 1, before turning the
appliance on.
3.2.2. Unroll the poser cord completely before
plugging it in.
3.2.3. Connect the appliance to the mains.
3.2.4. Turn the appliance on by using the selector
control.
3.2.5. Select the desired function: 0(stop/infra-
red), 1(Vibration and infrared), 2(bubbles and
infrared), 3(bubbles, vibration and infrared).
3.2.6. To use the massage rollers, roll your feet
backwards and forwards over them.
3.3. Pedicure/manicure set:
3.3.1. Insert the batteries into the specific com-
partment, taking care to position the polarities (+
/- signs) as shown (2 x 1.5V AA- Batteries not
included)
3.3.2. Attach the desired accessory (depending
on the operation you wish to perform, as speci-
fied below).
3.3.3. The switch on the appliance allows you to
choose from two speeds in each direction.
3.3.4. Immerse your hands/feet in warm, soapy
water. Dry carefully.
ACCESSORIES
• Attachment 2- Disc to file nails.
NB: before use, remove the Blue PVC Protection
Film.This accessory can shape and re-define
even the thickest, hardened nails. Regular use
makes nails stronger and more hardwearing and
is suitable for both fingernails and toenails.
• Attachment 3- Polishing disc
To polish the tips of the nails after filing, and to
polish the nail surface.
• Attachment 4- precision head
To remove and raise hardened cuticles and to
clean nails
• Attachment 5- Wide head to remove callus and
shorten nails (Suitable
for toenails)
• Slim polishing head to remove callus and
shorten nails (hand nails)
Allow the accessory to slide carefully over the
areas to be treated.
For best results-
• Wash feet before beginning pedicure treatment
• After treatment, immerge feet (or hands) in
water and apply a moisturizing cream or lotion
(creams and lotions not supplied).
4. Cleaning and Maintenance
4.1.1. Turn the foot spa off by turning the dial to
the 0 position.
4.1.2. Unplug the foot spa from the mains.
4.1.3. Empty the water deposit by pouring
the water out, in the opposite direction as the
selector dial (DO NOT GET THE SELECTOR DIAL
WET).
4.1.4. Wipe the inner and outer with a damp
cloth.
4.1.5. Dry the foot spa before storing away.
4.1.6. Before clearing the pedicure set, ensure
that you have removed the batteries.
4.1.7. Never immerse the pedicure unit in water
or any other liquids.
4.1.8. Clean the pedicure unit and case with a
soft cloth slightly dampened with water.
4.1.9. Never use other liquids or abrasive deter-
gents. Always dry carefully.
4.1.10. To clean the accessories, use a soft
brush to remove any residues of skin and nails.
4.1.11. The discs and conical heads can be
cleaned with a damp soft brush.
5. Anomalies and repair
5.1. Take the appliance to an authorized support
center if product is damaged or other problems
arise.
5.2. If the connection to the mains has been
damaged, it must be replaced and you should
proceed as you would in the case of damage.