Munters LOR 2 FE Manual De Instrucciones página 10

Position the heater on a flat, level, non-flammable, solid surface. Connect the plug to an
earthed 230V 50Hz single-phase electrical outlet.
Ensure a minimum 1 m safety clearance between the heater and any surrounding
objects and materials, on all sides.
Only operate the heater in normal upright position.
Do not place the heater near walls, corners or low ceilings.
Do not place the heater below a socket outlet.
Do not place the heater on moving vehicles or where it can tip over.
Keep the heater away from flammable, combustible, explosive or corrosive
materials.
Keep the heater away from curtains or similar materials that could block the air
inlet and outlet.
Keep the power cable away from heat sources, sharp edges, cutting and moving
parts.
For indoor use only. Do not expose to the weather or to humidity.
Do not place the heater in the immediate surroundings of a bath, shower or
swimming pool.
Do not use plug adaptors.
4. Instructions for Use
Turn the power selector switch to O, unplug the heater and let it cool down before storing it.
t
Do not cover the heater. Do not block the air inlet and outlet.
The heater outlet is very hot during operation and after use. Do not touch!
Children should be supervised to ensure that they do not play with the appliance.
The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge.
Unplug the heater before moving it. Never pull the cable to unplug or move the
unit.
Do not leave the heater unattended when in use.
Do not use the heater with a programmer, timer or any other device that can
switch the heater on automatically.
Start
Turn the thermostat knob to maximum.
Turn the power selector switch to the desired position: I
(1000 W) or II (2000 W). The heater will start.
As the desired room temperature is reached, turn the
thermostat knob back and stop it as you hear a click. The
thermostat will cycle the heater on and off to maintain a
constant room temperature.
Note: when you start the heater for the first time, some smell
may be released from the PTC elements: this is a normal
effect that will cease in a few hours.
Shutdown
GB