Parts Included - EDM Product 50133 Instrucciones De Uso

INSTRUCCIONES IMPORTANTES DE SEGURIDAD
50133
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
GENERAL INFORMATION
Make sure to use the studs in your wall before mounting the wall plate. Do not mount this
product into the drywall.
- Distance min / max. the wall: 60mm
- Tilt angle: -15º / +15°

PARTS INCLUDED

A.- Four plastic anchors
B.- Four two inch heavy duty screws
C.- Four 1/2" mounting screws
D.- Four 3/4" mounting screws
E.- Eight washers ( 4 large and 4 small)
F.- One long horizontal base plate
G.- Two 17" long vertical brackets with bolts attached
WARNING
- Use caution when hanging heavy objects
- Hang only flat screen televisions on wall mount.
- Not for children
NOTE
Please note it is recommended that this product requires fixing by a professional to avoid
accidental damage or injury. The supplier will not be held liable for damage caused by
inadequate fixing.
INSTALLATION
1. Take out base plate(F) from the package.
2. Drill four holes into the wall taking care to measure the distances to fit the wall mount body.
Insert the four plastic anchors (A) into the holes and then affix the wall mount body to the wall
by inserting the four 2 inch heavy duty screws(B) through the slots and into the anchors.
Make sure the slotted openings are hanging down the ledge is facing towards you. Use a drill
to secure.
3. Fix the two vertical brackets (H) with flat TV by using suitable screws(C/D/E) and washers
(F).
4. Lift the vertical brackets (H) along with the TV screen hang onto the ledges of the base
plate (G). Use the attached bolts to tighten the vertical brackets (H).
5. Loosen the knob to adjust the angle of the TV between -15º/+15º degrees to a suitable
position, and then screw the knobs firmly.