Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from valve(s) at low point(s) of piping,
air fi lter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose cou-
pling without internal shut-off , to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 47113980 and table on page 2. Maintenance frequency is shown in a circular arrow and defi ned as h=hours, d=days,
and m=months of actual use. Items identifi ed as:
1.
Air fi lter
2.
Regulator
3.
Lubricator
4.
Emergency shut-off valve
5.
Hose diameter
6.
Thread Size
Oiler Adjustment
To adjust oiler, remove the Backhead and turn the Oiler Adjusting Screws . Turning the Screws in (clockwise) reduces the oil fl ow. Backing
the Screws out increases the oil fl ow. The oil fl ow can be controlled by turning either Screw.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Offi ce or Distributor.
EN-2
7.
Coupling
8.
Safety Air Fuse
9.
Oil
10.
Grease - during assembly
11.
Grease - through fi tting
03523024_ed23
Publicidad
Tabla de contenido
